Skip Navigation Links | |
Exit Print View | |
![]() |
System Administration Guide: Network Services Oracle Solaris 11 Express 11/10 |
Part I Network Services Topics
Part II Accessing Network File Systems Topics
4. Managing Network File Systems (Overview)
5. Network File System Administration (Tasks)
6. Accessing Network File Systems (Reference)
8. Planning and Enabling SLP (Tasks)
10. Incorporating Legacy Services
Part V Serial Networking Topics
15. Solaris PPP 4.0 (Overview)
16. Planning for the PPP Link (Tasks)
17. Setting Up a Dial-up PPP Link (Tasks)
18. Setting Up a Leased-Line PPP Link (Tasks)
Setting Up a Leased Line (Task Map)
Configuring a Machine on the Leased Line
Prerequisites for Configuring the Local Machine on a Leased Line
How to Configure a Machine on a Leased Line
19. Setting Up PPP Authentication (Tasks)
20. Setting Up a PPPoE Tunnel (Tasks)
21. Fixing Common PPP Problems (Tasks)
22. Solaris PPP 4.0 (Reference)
23. Migrating From Asynchronous Solaris PPP to Solaris PPP 4.0 (Tasks)
25. Administering UUCP (Tasks)
Part VI Working With Remote Systems Topics
27. Working With Remote Systems (Overview)
28. Administering the FTP Server (Tasks)
29. Accessing Remote Systems (Tasks)
Part VII Monitoring Network Services Topics
The task in this section involves configuring equipment that is required by the leased-line topology that is introduced in Example of a Configuration for a Leased-Line Link. The synchronous devices that are required to connect to the leased line include the interface and modem.
Before you perform the next procedure, you must have the following items:
Working leased line that is installed at your site by the provider
Synchronous unit (CSU/DSU)
Oracle Solaris release installed on your system
Synchronous interface card of the type that is required by your system
Follow the instructions in the manufacturer's documentation.
If necessary, connect cables from the CSU/DSU to the leased-line jack or similar connector.
Note - The provider from whom you rented the leased line might supply and configure the CSU/DSU for your link.
The configuration of the interface card involves the creation of a startup script for the interface. The router at LocalCorp in the leased-line configuration that is shown in Figure 16-2 uses an HSI/P interface card.
The following script, hsi-conf, starts the HSI/P interface.
#!/bin/ksh /opt/SUNWconn/bin/hsip_init hihp1 speed=1536000 mode=fdx loopback=no \ nrzi=no txc=txc rxc=rxc txd=txd rxd=rxd signal=no 2>&1 > /dev/null
Indicates that HSI/P is the synchronous port used
Set to indicate the speed of the CSU/DSU
To configure the local machine on the leased line, refer to How to Configure a Machine on a Leased Line.