JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Server X2-8 (formerly Sun Fire X4800 M2) Service Manual     Sun Server X2-8 (formerly Sun Fire X4800 M2) Documentation Library
Oracle Technology Network
Library
PDF
Print View
Feedback
search filter icon
search icon

Document Information

Using This Documentation

Sun Server X2-8 Name Change

Product Downloads

Documentation and Feedback

About This Documentation

Change History

Sun Server X2-8 Service Manual Overview

Server and Component Overview

Sun Server X2-8 Overview

Component Overviews

Power and Reset

Power Modes

Power Button and Power OK LED

How to Power On the Server

How to Power Off the Server

Controlling Server Power Remotely

Removing and Installing Components

Preparing for Service and Operation

Removal and Installation Procedures

Removing and Installing a Power Supply (CRU)

Removing and Installing a Hard Drive (CRU)

Removing and Installing a Hard Drive Filler

Replacing the Hard Drive Backplane (FRU)

Adding, Removing, and Installing a CMOD (CRU)

How to Add a CPU Module (CMOD) to the Server Using the Upgrade Kit

How to Remove a CPU Module (CMOD)

How to Remove the CPU Module (CMOD) Cover

How to Install the CPU Module (CMOD) Cover

How to Install a CPU Module (CMOD)

How to Verify CPLD Versions

CPU Module (CMOD) Designation and Population Rules

Removing and Installing a CMOD Filler

How to Replace the CMOD Battery (CRU)

Removing and Installing DIMMs (CRU)

DIMM Population Rules

Removing and Installing a RAID Expansion Module (CRU)

Removing and Installing a Fabric Expansion Module (CRU)

Replacing a CPU and Heatsink Assembly (FRU)

Removing and Installing a Fan Module (CRU)

Replacing a Fan Module Controller Board (FRU)

Removing and Installing a NEM or a NEM Filler (CRU)

Removing and Installing a PCIe EM (CRU)

Removing and Installing the Service Processor Module (CRU)

Removing and Installing the Multiport Cable

Removing and Installing the Subassembly Module (FRU)

Sun Server X2-8 Service Procedures and Information

Managing FRUID Information

Firmware Information and Procedures

How to Access the BIOS Setup Utility

BIOS Setup Utility Screens

Component LED Locations and Functions

Thermal Sensor Locations

Sun Server X2-8 Specifications

Physical Specifications

Power Specifications

Environmental Specifications

Requesting Physical Media

How to Request Physical Media Online

How To Request Physical Media by Phone

Index

How to Install the CPU Module (CMOD) Cover

Before You Begin

About Sun Server X2-8 CPU Modules and CMOD Filler Modules

  1. Set the cover on top of the CMOD with the cover release button toward the front of the module and with approximately 0.5 inch of the cover overhanging the rear of the module.

    This leaves a gap of approximately 0.5 inch between lead edge of the cover and front top edge of the CMOD chassis. The cover should sit evenly on top of the module.


    image:CPU module (CMOD) cover install.
  2. Slide the cover toward the front of the module until it stops, taking care that the lead edge of the cover slides under the front top edge of the CMOD.

    When the cover is properly installed, this action produces a click sound as the cover latch engages and locks the cover.

  3. Ensure that the cover is locked in place.

    The cover should not move unless the release button is pressed.

Next Steps

How to Install a CPU Module (CMOD)

See Also

How to Remove the CPU Module (CMOD) Cover

Copyright © 2011, 2013, Oracle and/or its affiliates. All rights reserved. Legal Notices
Previous Next