If you need to install and configure a Sun Ray server in a different way than what the utsetup command provides, you must run the individual commands as noted in the previous section. The following situations may force you to do this:
Using JumpStart (Solaris) or Kickstart (Linux) to install the software.
Using a different network configuration besides a shared network. See the Alternate Network Configurations chapter in the Administration Guide for information about the other network configurations that are supported.
Configuring the Sun Ray Software without the Sun Ray data store, which is known as zero administration mode.
This document does not provide detailed instructions about how to use the individual commands to install and configure Sun Ray Software without the utsetup command. Refer to the man pages for the following commands:
utinstall
utconfig
utpolicy
utadm
utfwadm
utreplica
utstart