Optionally, you may specify calculation details associated with a billable charge. These are most commonly used when you need to print the details that were used to calculate the bill lines that appear on the main tab.
Open and navigate to the Calculation Details tab to maintain a billable charge's rate quantities.
Description of Page
The grid is a snapshot of the details that were billed using the bill lines shown on the main tab. One row exists for every calculation detail that should be swept onto the related bill segment when the system creates a bill segment for this billable charge. The following information is displayed in the grid:
Final Unit of Measure is the final unit of measure of the calculation / audit read.
Final Time of Use is the final time-of-use code of the calculation / audit read.
Final RQI is the final rate quantity identifier of the calculation / audit read.
Final Quantity is the quantity of the calculation / audit read. This would typically contain the amount that was billed during the Start Date/Time through the End Date/Time for the Final Unit of Measure, Final Time of Use and Final RQI.
Sequence is the sequence number (if any).
Unit of Measure is the initial unit of measure of the calculation / audit read (if any).
Time of Use is the initial time-of-use code of the calculation / audit read.
RQI is the initial rate quantity identifier of the calculation / audit read.
Start Quantity is the "start" quantity (if any). This value would typically only be displayed if the calculation / audit read is subtractive (i.e., you must subtract the end quantity from the start quantity to determine billable quantity).
End Quantity is the "end" quantity (if any). This value would typically only be displayed if the calculation / audit read is subtractive (i.e., you must subtract the end quantity from the start quantity to determine billable quantity).
Quantity is the resulting measured quantity (if any). This value would typically only be displayed if the calculation / audit read is subtractive (i.e., you must subtract the end quantity from the start quantity to determine billable quantity). It should contain the difference between the Start Quantity and the End Quantity.
Constant is the constant of the measuring device that was multiplied by the Quantity to derive the calculation / audit read's Final Quantity.
How To Use is a code that indicates if the "calculation / audit" read is considered to be additive, subtractive, peak or check.
Use Percent is the percentage of the total quantity that was billed.
Measures Peak Qty indicates if the unit of measure is one that measures a peak amount.
Start Date/Time is the date and time of the calculation / audit read.
End Date/Time is the date and time of the calculation / audit read.
Multiplier is the ratio of the Final Quantity and the Quantity. This value only appears if a non-zero value exists in both of these fields.
The multiplier is calculated by dividing the Final Quantity by the Quantity (if the Quantity is 0, then the result is 0). This is not stored on the database. There is a chance that the value is not precise due to round-off.
Copyright © 2011, Oracle and/or its affiliates. All rights reserved.