Skip Navigation Links | |
Exit Print View | |
![]() |
Oracle Solaris Cluster Geographic Edition System Administration Guide Oracle Solaris Cluster 4.0 |
1. Introduction to Administering the Geographic Edition Software
3. Administering the Geographic Edition Infrastructure
4. Administering Access and Security
5. Administering Cluster Partnerships
Configuring Trust Between Partner Clusters
How to Configure Trust Between Two Clusters
How to Remove Trust Between Two Clusters
Creating and Modifying a Partnership
How to Modify Partnership Properties
Joining an Existing Partnership
How to Add a New Node to a Cluster in a Partnership
Renaming a Cluster That Is in a Partnership
How to Rename a Cluster That Is in a Partnership
How to Resynchronize a Partnership
7. Administering Protection Groups
8. Monitoring and Validating the Geographic Edition Software
9. Customizing Switchover and Takeover Actions
A. Standard Geographic Edition Properties
B. Legal Names and Values of Geographic Edition Entities
C. Disaster Recovery Administration Example
E. Troubleshooting Geographic Edition Software
You can also use the geops command to remove a cluster from a partnership and release all the resources that are associated with the partnership.
Because this command destroys the local partnership configuration information, when the last member leaves a partnership, the partnership no longer exists.
Before You Begin
Ensure that the following conditions are met:
The local cluster is a member of the partnership you want to leave.
This partnership does not contain any protection groups.
You must be assigned the Geo Management RBAC rights profile to complete this procedure. For more information about RBAC, see Geographic Edition Software and RBAC.
# geopg list
If you find that the partnership contains protection groups, you can delete them with the geopg delete command. For information about deleting protection groups, see one of the following data replication guides:
# geops leave-partnership partnershipname
Specifies the name of the partnership
Note - The geops leave-partnership command deletes the heartbeats configured for the partnership, including custom heartbeats.
For more information, refer to the geops(1M) man page.
Example 5-6 Leaving a Partnership
In this example, the cluster-paris cluster leaves the paris-newyork-ps partnership.
phys-paris-1# geops leave-partnership paris-newyork-ps
Example 5-7 Deleting a Partnership
After the cluster-paris cluster leaves the paris-newyork-ps partnership, as described in the previous example, the only remaining member of the partnership is the cluster-newyork cluster. You can delete the paris-newyork-ps partnership by forcing the cluster-newyork cluster to leave the partnership.
phys-newyork-1# geops leave-partnership paris-newyork-ps
Next Steps
Repeat this procedure on the other cluster in the partnership.