Specifies the timeout period for
the protection group in seconds. The timeout period is the longest time Geographic
Edition waits for a response after you run a geopg
command, such as
, geopg stop
, geopg switchover
, and geopg takeover
. If the command does not respond within
the timeout period, the Geographic Edition software reports the operation as timed out,
even if the underlying command eventually completes successfully.
You should identify the amount of
time required to perform a role-reversal of the data replication, and set the
timeout value to 150% to 200% of that value to ensure enough time
for the role-reversal to complete.
To ensure that an operation has finished on
the remote cluster, check system status after a timeout before attempting the operation
again. For more information, see Troubleshooting Migration Problems.
The timeout period applies to operations on a
per-cluster basis. An operation with a local scope times out if the operation
does not complete after the specified timeout period.
An operation with a global scope
consists of an action on the local cluster and an action on the
remote cluster. The local and remote action are timed separately so that an
operation with a global scope times out during one of the following conditions:
recommendations: This property can be tuned only when the protection group is offline.
Range: 20-1000000 seconds