Skip Navigation Links | |
Exit Print View | |
Oracle Solaris Administration: IP Services Oracle Solaris 11 Information Library |
1. Planning the Network Deployment
2. Considerations When Using IPv6 Addresses
3. Configuring an IPv4 Network
Network Configuration (Task Map)
Configuring Component Systems on the Network
IPv4 Autonomous System Topology
How to Configure an IP Interface
Setting Up System Configuration Modes
How to Configure a System for Local Files Mode
How to Configure a System for Network Client Mode
How to Set Up a Network Configuration Server
How to Configure an IPv4 Router
Routing Tables and Routing Types
How to Add a Static Route to the Routing Table
How to Create a Multihomed Host
Configuring Routing for Single-Interface Systems
How to Enable Static Routing on a Single-Interface Host
How to Enable Dynamic Routing on a Single-Interface System
How to Change the IPv4 Address and Other Network Configuration Parameters
Monitoring and Modifying Transport Layer Services
How to Log the IP Addresses of All Incoming TCP Connections
How to Add Services That Use the SCTP Protocol
How to Use TCP Wrappers to Control Access to TCP Services
4. Enabling IPv6 on the Network
5. Administering a TCP/IP Network
7. Troubleshooting Network Problems
11. Administering the ISC DHCP Service
12. Configuring and Administering the DHCP Client
13. DHCP Commands and Files (Reference)
14. IP Security Architecture (Overview)
16. IP Security Architecture (Reference)
17. Internet Key Exchange (Overview)
19. Internet Key Exchange (Reference)
20. IP Filter in Oracle Solaris (Overview)
Part IV Networking Performance
22. Integrated Load Balancer Overview
23. Configuration of Integrated Load Balancer (Tasks)
24. Virtual Router Redundancy Protocol (Overview)
25. VRRP Configuration (Tasks)
26. Implementing Congestion Control
Part V IP Quality of Service (IPQoS)
27. Introducing IPQoS (Overview)
28. Planning for an IPQoS-Enabled Network (Tasks)
29. Creating the IPQoS Configuration File (Tasks)
30. Starting and Maintaining IPQoS (Tasks)
31. Using Flow Accounting and Statistics Gathering (Tasks)
In this Oracle Solaris release, a system's network configuration is managed by an active network configuration profile (NCP). If the active NCP in the system is automatic, then network configuration is automatically managed by the OS. If the active NCP is DefaultFixed, then network configuration is performed manually by using the dladm and ipadm commands.
Note - The dladm and ipadm commands do not work if the active NCP is Automatic.
For procedures to determine the system's active profile and to switch to a fixed NCP, see Profiles and Configuration Tools in Oracle Solaris Administration: Network Interfaces and Network Virtualization.
For more information about NCPs, refer to Part I, Network Auto-Magic, in Oracle Solaris Administration: Network Interfaces and Network Virtualization.
In this documentation, the procedures assume that the active NCP on all of the systems on the network is DefaultFixed.