sdpadm

- SDP system configuration administration

用法概要

/usr/sbin/sdpadm status | enable | disable

描述

The sdpadm command is no longer shipped with the Oracle Solaris operating system. SDP sockets are enabled by default. This man page describes a utility that was shipped in prior builds of the operating system.

The sdpadm command is used to display the system state of the Sockets Direct Protocol (SDP) protocol. The sdpadm command can optionally be used to set the state of the SDP protocol. See sdp(7D).

By default the SDP protocol is disabled on the system. It can be enabled by using sdpadm enable.

选项

The following subcommands are supported:

status

Displays the system status of the SDP protocol

enable

Enables the SDP protocol

disable

Disables the SDP protocol

用法

The required privileges to change the state of the SDP protocol are controlled by the network configuration policy. If a user does not have the correct privileges to set the SDP policy, sdpadm returns the current state of SDP without having changed the state.

属性

See attributes(5) for descriptions of the following attributes:

另请参见

attributes(5), sdp(7D)

Infiniband Specification Volume 1 (http://www.infinibandta.org)