A script enabled browser is required for this page to function properly.
Skip to main content
STA Reference Guide, v1.0.2
E28382-03
Table of Contents Previous Next Index


Drives Overview and Analysis Screens : Drive Attribute Definitions : Additional Exchange Information for Enterprise Drives

Additional Exchange Information for Enterprise Drives

Additional details about the drive’s most recent exchange. This section appears only for StorageTek enterprise drives, such as 9840D or T10000C.

Attribute

Definition

Exchange FSC

Four-byte hexadecimal fault symptom code (FSC). For example, FD55, S053, etc. Reported only if an error occurred during the exchange.

Exchange Write Inefficient

Indicates whether the drive failed to meet the write efficiency standard for the drive type. Available only for StorageTek T10000A and above and IBM LTO3 and above drives. Possible values: Yes or No.

Exchange Read Marginal

Indicates whether the drive met the read margin standard for the drive type. Available only for StorageTek T10000A and above drives. Possible values: Yes or No.

Exchange Write Efficiency

Write efficiency for the exchange, based on capacity over distance. A high value is desirable.

Exchange Read Margin

Amount of error correction code (ECC) read margin remaining on the media, as reported by the drive during the last mount. Reported as a percentage. A high value is desirable.

If STA determines that this value has gone below a threshold for this drive type, the Exchange Read Marginal attribute is set to Yes.

Time Spent Reading

Total time the drive spent reading data during the exchange

Time Spent Writing

Total time the drive spent writing data during the exchange

Time Spent Reading or Writing

Total time the drive spent reading and writing data during the exchange

Read MB/sec

Read rate for the time spent actively reading; idle time is excluded. Expressed in megabytes per second. Calculated as:

compressed MB read / total read time 

Write MB/sec

Write rate for the time spent actively writing; idle time is excluded. Expressed in megabytes per second. Calculated as:

compressed MB written / total write time 

R/W MB/sec

Throughput rate for the time spent actively reading and writing; idle time is excluded. Expressed in megabytes per second. Calculated as:

(compressed MB read + compressed MB written) / 
(read time + write time)

Read Mount Ratio

Ratio of read time to total mount time. Calculated as:

read time / total mount time

Write Mount Ratio

Ratio of write time to total mount time. Calculated as:

write time / total mount time 

R/W Mount Ratio

Ratio of read and write time to total mount time. Displayed as a percentage. A value close to 1.0 indicates the drive is active over the entire mount. Calculated as:

(read time + write time) / total mount time 

Exchange Encryption Used

Encryption method used by the drive for the exchange. Available for StorageTek enterprise drives only. Possible values:

Encrypted_ANSI_10 – ANSI encryption.
Encrypted Sun KMS – Oracle Key Manager (OKM) encryption.
Not Encrypted – Not encrypted.
Unknown – The drive did not report encryption information.

Table of Contents Previous Next Index Link to documentation
Copyright © 2012 Oracle and/or its affiliates. All rights reserved.