2.2.5 Kickstart installation fails on multipath device when the ignoredisk --only-use option is used

A kickstart installation fails when the ignoredisk --only-use option is used to point to a multipath device. This problem occurs because multipath is not started by the time that the installer searches the multipath map to match the device.

Rather than use the ignoredisk --only-use option, specify which drives should not be used in the partitioning section by using the ignoredisk --drives option, as shown in the following example:

clearpart --all --initlabel
ignoredisk  --drives=sda,sdb
part /boot --fstype=ext4 --size=500 --asprimary 
      --ondisk=/dev/disk/by-id/scsi-3600144f0cab1f53e000058a15c870904
part / --fstype=ext4 --size=8192 --grow --maxsize=51200 --asprimary 
      --ondisk=/dev/disk/by-id/scsi-3600144f0cab1f53e000058a15c870904
part swap --size=16384 --asprimary 
      --ondisk=/dev/disk/by-id/scsi-3600144f0cab1f53e000058a15c870904

(Bug ID 25548146)