Go to main content

Oracle® Solaris 11.4 DTrace (Dynamic Tracing) Guide

Exit Print View

Updated: September 2020
 
 

Limit Enabled Probes

Dynamic instrumentation techniques enable DTrace to provide unparalleled tracing coverage of the kernel and of arbitrary user processes. While this coverage allows revolutionary new insight into system behavior, it also can cause enormous probe effect. If tens of thousands or hundreds of thousands of probes are enabled, the effect on the system can easily be substantial. Therefore, you should only enable as many probes as you need to solve a problem. Do not, for example, enable all FBT probes if a more concise enabling answers your question. For example, your question might allow you to concentrate on a specific module of interest or a specific function.

When using the pid provider, you should be especially careful. Because the pid provider can instrument every instruction, you could enable millions of probes in an application, and therefore slow the target process to a crawl.

DTrace can also be used in situations where large numbers of probes must be enabled for a question to be answered. Enabling a large number of probes might slow down the system quite a bit, but it will never induce fatal failure on the system. You should therefore not hesitate to enable many probes if required.