Configuring the SLB Topology Example
SLB Configuration Guidelines and Prerequisites
Configuring the SLB-L2 Topology Example
SLB-L2 Configuration Guidelines and Prerequisites
Conditions for a Member Participating in Load Distribution
Set the Traffic Distribution Policy
Restore the Default Traffic Distribution Policy
Set the Health-Monitor Parameters
View the Traffic Distribution Policy
Restore the Default Traffic Distribution Policy
Restore the Default Failover Method
Creating Example SLB Configurations
Creating a Basic SLB Configuration
Enable the Switch Ports (Basic SLB)
Save the Current Configuration (Basic SLB)
Creating a Separate VLAN SLB Configuration
Separate VLAN SLB Configuration
Configuration With Separate VLANs Steps
Set Up the Switch (Separate VLAN SLB)
Set Up the Client (Separate VLAN SLB)
Set Up the Server (Separate VLAN SLB)
Enable the Switch Ports (Separate VLAN SLB)
Save the Current Configuration (Separate VLAN SLB)
Creating a Multiple SLB Group Configuration
Multiple-SLB-Group Configuration
Configuration With Multiple SLB Groups Steps
Set Up the Client (Multiple SLB Group)
Set Up the Servers in SLB Group 1
Set Up the Servers in SLB Group 2
Enable the Switch Ports (Multiple SLB Group)
Save the Current Configuration (Multiple SLB Group)
Restart the Server Following Failure
Creating SLB-L2 Configuration Examples
Bump-In-The-Wire Configuration
Creating a Single-Switch Configuration
Basic Single-Switch Configuration
Create a Single-Switch Configuration
Creating a Dual-Switch Configuration
Create a Dual-Switch Configuration
When you add a server member as the first member of the group, an LBG is created. This example shows adding two server entries, as well as a single standby server, to an LBG.
SEFOS# configure terminal SEFOS(config)# slb 10.10.10.0 255.255.255.0 192.0.0.1,192.0.0.2
SEFOS# configure terminal SEFOS(config)# slb standby 10.10.10.0 255.255.255.0 192.0.0.3 SEFOS(config)# end
The following example shows LBG with one active SLB server member and one standby SLB server member. For information about the status of a server member, see Conditions for a Member Participating in Load Distribution.
SEFOS# show slb SLB Group ID: 1 Virtual IP: 10.10.10.0/24 Server Members: IP Address Vlan MacAddress Port State Comments ================ ==== ================= ==== ========= ================== 192.0.0.1 1 00:14:4f:3e:e0:10 3 ACTIVE 192.0.0.2 1 00:14:4f:3e:e0:15 8 IDLE 192.0.0.3 1 00:14:4f:3e:e0:19 12 STANDBY (up)