Skip Headers
Oracle® Communications Design Studio Modeling Inventory
Release 7.2.4
Go to Design Studio Help Home
Go to Table of Contents
Go to Feedback page

Go to previous page
Go to next page
Mobi · ePub

Capacity Required Specification Editor Properties Tab

Use the Properties tab to create a new capacity type or select an existing one.

Field Use
Capacity Type Determines the type of capacity offered, defined by a capacity type.

Do one of the following:

  • Click Capacity Type to create a new capacity type.

  • Click Select to select from existing capacity types.

  • Click Clear to remove a previous selection.

Required Amount Enter the amount of the capacity type that an entity requires.
Unit of Measure Select the units by which the total amount is measured, defined by a Unit of Measure specification.

Do one of the following:

  • Click the link to create a new unit of measure.

  • Click Select to select from existing units of measure.

  • Click Clear to remove a previous selection.

Quantity Specify the quantity of the required amount. Typically, this value is set to 1. If the capacity required must be consumed as a set of units, such as channels provided by a facility pipe, set the Quantity to the number of units required. The capacity required of each unit is equal to the value set in the Required Amount field. The total amount of capacity required is equal to the value defined in the Required Amount field times the value defined in the Quantity field.

Related Topics

Configuring Capacity Required Specifications

Capacity Required Specification Editor