Skip Headers
Oracle® Communications Design Studio Modeling Inventory
Release 7.2.4
Go to Design Studio Help Home
Go to Table of Contents
Go to Feedback page

Go to previous page
Go to next page
Mobi · ePub

Pipe Signal Termination Point Specification Editor Compatible Signals Tab

You use the Compatible Signals tab to select Pipe Signal Termination Point specifications that include compatible capacity unit amounts. These are capacities that the signal can support even though they are not an exact match for the main capacity unit amount. For example, you can configure a SONET STS1 51.840 Mbps channel to support a DS3 facility at a rate of 44.736 Mbps in addition to an STS transmission facility of exactly 51.840 Mbps.

Field Use
Supports Signals Displays all supported Pipe Signal Termination Point specifications.
Supported By Signals Displays all Pipe Signal Termination Point specifications that are supported by the selected specification.
Select Click to select and add an existing Pipe Signal Termination Point specification.
Open Click to open the selected Signal Termination Point in the Pipe Signal Termination Point Specification editor.
Remove Click to remove the selected Pipe Signal Termination Point specification.
Add Click to create and add a new Pipe Signal Termination Point specification.