Creating an IPMP group using probe-based and link-state failure detection
Do not use probe-based failure detection when there no systems (other than the
cluster peer) on the same subnet as the IPMP test addresses that are configured
to answer ICMP echo requests.
Create one or more "underlying" IP interfaces that will be used as
components of the IPMP group. Each interface must have an IP address to be
used as the probe source (see separate task to create a single-port
Click the Interface
Optionally change the name of the interface.
Click the IP MultiPathing Group check box.
Click the Use IPv4 Protocol or/and the Use IPv6 Protocol and specify the
IP addresses for the IPMP interface.
Choose the interfaces created in the fist step from the Interfaces
Set each chosen interface to be either "Active" or "Standby", as