JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Oracle® ZFS Storage Appliance Administration Guide
Oracle Technology Network
Print View
search filter icon
search icon

Document Information

Using This Documentation

Chapter 1 Oracle ZFS Storage Appliance Overview

Chapter 2 Status

Chapter 3 Initial Configuration

Chapter 4 Network Configuration

Network Configuration Page



Network Interfaces

Network IP MultiPathing (IPMP)

Network Performance and Availability

Network Routing Configuration

Network Routing Entries

Network Routing Properties

Network Configuration Using the BUI

Network Configuration Page

Network Addresses

Network Routing Page

Network Configuration Using the CLI

Network Configuration Tasks Using the BUI

Creating a single port interface

Modifying an interface

Creating a single port interface, drag-and-drop

Creating an LACP aggregated link interface

Creating an IPMP group using probe-based and link-state failure detection

Creating an IPMP group using link-state only failure detection

Extending an LACP aggregation

Extending an IPMP group

Creating an InfiniBand partition datalink and interface

Creating a VNIC without a VLAN ID for clustered controllers

Creating VNICs with the same VLAN ID for clustered controllers

Adding a static route

Deleting a static route

Network Configuration Tasks Using the CLI

Adding a static route

Deleting a static route

Changing the multihoming property to strict

Chapter 5 Storage Configuration

Chapter 6 Storage Area Network Configuration

Chapter 7 User Configuration

Chapter 8 Setting ZFSSA Preferences

Chapter 9 Alert Configuration

Chapter 10 Cluster Configuration

Chapter 11 ZFSSA Services

Chapter 12 Shares, Projects, and Schema

Chapter 13 Replication

Chapter 14 Shadow Migration

Chapter 15 CLI Scripting

Chapter 16 Maintenance Workflows

Chapter 17 Integration


Network Interfaces

Network interfaces configure IP addresses via datalinks. They following are supported:

The following interface settings are available:

Table 4-4  Interface Settings
Custom name for the interface
Allow Administration
Allow connections to the appliance administration BUI or CLI over this interface. If your network environment included a separate administration network, this could be enabled for the administration network only to improve security
Enable Interface
Enable this interface to be used for IP traffic. If an interface is disabled, the appliance will no longer send or receive IP traffic over it, or make use of any IP addresses configured on it. At present, disabling an active IP interface in an IPMP group will not trigger activation of a standby interface.
IPv4 Configure with
Either "Static Address List" manually entered, or "DHCP" for dynamically requested
IPv4 Address/Mask
One or more IPv4 addresses in CIDR notation (
IPv6 Configure with
Either "Static Address List" manually entered, or "IPv6 AutoConfiguration" to use automatically generated link-local address (and site-local if an IPv6 router responds)
IPv6 Address/Mask
One or more IPv6 addresses in CIDR notation (1080::8:800:200C:417A/32)
IP MultiPathing Group
Configure IP multipathing, where a pool of datalinks can be used for redundancy