|Skip Navigation Links|
|Exit Print View|
Oracle® ZFS Storage Appliance Customer Service Manual
For ZS3-x, 7x20 Controllers, and DE2-24, Sun Disk Shelves
The Sun ZFS Storage 7120 is an enterprise-class two-socket rackmount x64 system powered by the Intel Xeon processor. It packs high performance and room for growth with four PCIe slots and 18 DIMM slots into a compact 2U footprint. Refer to the product site at http://www.oracle.com/us/products/servers-storage/storage/nas/overview/index.htmlhttp://www.oracle.com/us/products/servers-storage/storage/nas/overview/index.html for the most recent component specification.
Refer to the white paper Implementing Fibre Channel SAN Boot with Oracle's Sun ZFS Storage Appliance at http://www.oracle.com/technetwork/articles/servers-storage-admin/fbsanboot-365291.htmlhttp://www.oracle.com/technetwork/articles/servers-storage-admin/fbsanboot-365291.html for details on FC SAN boot solutions using the Sun ZFS Storage 7120.
The 7120 is a standalone controller that consists of an internal SAS-2 HBA providing disk shelf expansion, write flash acceleration, and 11 x 300GB 15K, 600GB 15K, 1TB 7.2K, 2TB 7.2K, or 3TB 7.2K hard drive storage. The SAS-2 storage fabric supports a greater number of targets, greater bandwidth, higher reliability, and bigger scale.
The 2U chassis form factor dimensions are as follows:
The following figure and legend show the front panel and the drive locations. The Logzilla 3.5" SSD belongs in slot 3 and is not supported in controllers configured with the internal Sun Aura flash HBA Logzilla.
Figure 2-25 7120 Controller Front Panel
The following figure and legend show the rear panel.
Figure 2-26 7120 Controller Rear Panel
The serial management connector (SER MGT) is an RJ-45 port and provides a terminal connection to the SP console.
Figure 2-27 7120 Controller Serial Management Port
The network management connector (NET MGT) is an RJ-45 port and provides an alternate terminal interface to the SP console.
Figure 2-28 7120 Controller Network Management Port
There are four RJ-45 Gigabit Ethernet ports (NET0, NET1, NET2, NET3) located on the motherboard that operate at 10/100/1000 Mbit/sec. These network interfaces must be configured before use.