Use this task to configure a new Command Code.
The fields are described in Command Codes elements.
- Select Diameter > Configuration > Command Codes.
The Diameter > Configuration > Command Codes page appears.
- Click Insert.
The Diameter > Configuration > Command Codes [Insert] page appears.
If the maximum number of Command Codes (1000) has already been configured in the system, the Diameter > Configuration > Command Codes [Insert] page will not open, and an error message will appear.
- Enter a unique Command Code Name for the Command Code.
- Select a Command Code from the menu or enter a unique value to identify a specific Command Code (Command Code is required.)
- Click:
- OK to save the new Command Code and return to the Diameter > Configuration > Command Codes page.
- Apply to save the new Command Code and remain on this page.
- Cancel to return to the Diameter > Configuration > Command Codes page without saving any changes.
If
OK or
Apply is clicked and any of the following conditions exist, an error message appears:
- Any fields contain a value that is out of the allowed range
- Any required field is empty (not entered)
- Adding the new Command Code would cause the maximum number of Command Codes (1000) to be exceeded