Editing Egress Throttle Groups

Use this task to edit Egress Throttle Groups.

When the Diameter > Configuration > Egress Throttle Groups [Edit] page opens, the columns are initially populated with the current configuration of the selected Egress Throttle Group.

The existing Egress Throttle Groups Name cannot be changed.

Changes can be made to an Egress Throttle Group configuration with either Rate Limiting Admin State or Pending Transaction Limiting Admin State in the Enabled or the Disabled state.

Changes can be made to an Egress Throttle Group configuration irrespective of the Operational Status of the associated Peer Connections.

Egress Throttle Groups fields are described in Egress Throttle Groups elements.

Select Diameter > Configuration > Egress Throttle Groups.
The Diameter > Configuration > Egress Throttle Groups page appears.
Select the Egress Throttle Groups to be edited, then click Edit.

The Diameter > Configuration > Egress Throttle Groups [Edit] page appears.
Update the relevant fields.
An entry in a pulldown list can be removed by selecting the entry in the list, and then clicking the X to the right of the pulldown list.
Click:
- OK to save the changes and return to the Diameter > Configuration > Egress Throttle Groups page.
- Apply to save the changes and remain on this page.
- Cancel to return to the Diameter > Configuration > Egress Throttle Groups page without saving any changes.
If OK or Apply is clicked and any of the following conditions exist, an error message appears:
- An attempt is made to remove the Rate Limiting Egress Throttling by removing the check from the corresponding Egress Throttlings check box for an Egress Throttle Group for which the Rate Limiting Admin State is set to Enabled.
- An attempt is made to remove Pending Transaction Egress Throttling by removing the check from the corresponding Egress Throttlings check box for an Egress Throttle Group for which the Pending Transaction Limiting Admin State is set to Enabled.