Use the following steps to start diagnosis on a test connection.
- Select Diameter > Maintenance > Connections.
The Diameter > Maintenance > Connections page appears.
- Select a single connection with the following conditions:
- Admin State is Enabled
- Test Mode is YES.
- PDUs to Diagnose is 0
- Click Diagnose Start.
A confirmation box appears.
- Click OK.
The selected test connection is under diagnosis. The PDUs to Diagnose value is set to the maximum diagnose PDU count.
If the selected connection no longer exists (it was deleted by another user), an error message is displayed and the Diameter > Maintenance > Connections page is refreshed.