Use the following steps to end diagnosis on a test connection.
- Select Diameter > Maintenance > Connections.
The Diameter > Maintenance > Connections page appears.
- Select a single connection with the following conditions:
- Admin State is Enabled
- Test Mode is YES.
- PDUs to Diagnose is greater than 0.
- Click Diagnose End.
A confirmation box appears.
- Click OK.
Diagnosis on the selected test connection is stopped. The PDUs to Diagnose value is set to 0.
If the selected connection no longer exists (it was deleted by another user), an error message is displayed and the Diameter > Maintenance > Connections page is refreshed.