Adding MCC Ranges

Use this task to configure new MCC Ranges.

MCC Ranges fields are described in MCC Ranges Elements.
  1. On the SOAM, select Diameter Common > Network Identifiers > MCC Ranges.

    The Diameter Common > Network Identifiers > MCC Ranges page appears.

  2. Click Insert.

    The Diameter Common > Network Identifiers > MCC Ranges page appears.

    If the maximum number of MCC Ranges (10) has already been configured in the system, the Diameter Common > Network Identifiers > MCC Ranges [Insert] page will not open, and an error message will appear.

  3. Enter a value for the Start MCC field.
  4. Enter a value for the End MCC field.
  5. Click:
    • OK to save the new MCC Range and return to the Diameter Common > Network Identifiers > MCC Ranges page.
    • Apply to save the new MCC Range and remain on this page. The data displayed on the page is updated.
    • Cancel to return to the Diameter Common > Network Identifiers > MCC Ranges page without saving any changes.

    If OK or Apply is clicked and any of the following conditions exist, an error message appears:
    • Any fields contain a value that is out of the allowed range
    • Any required field is empty (not entered)
    • Adding the new MCC Range would cause the maximum number of MCC Ranges (10) to be exceeded
    • The Start MCC field value is greater than the End MCC field value
    • The MCC Range created lies within the ranges of other MCC Ranges

Parent topic: MCC Ranges Configuration