Editing a supported Diameter application

A supported Diameter Application entry cannot be edited. Selecting a supported Diameter Application, clicking Edit, and changing the Application ID value results in an error message.

To change a supported Diameter Application entry:

Use the procedure in Inserting a supported Diameter application to insert the Diameter Application you want.
Use the procedure in Deleting a Diameter application from the list of supported Diameter applications to delete the Diameter Application you do not want.

Use this task to edit a supported Diameter Application entry.

Select RBAR > Configuration > Applications.
The RBAR > Configuration > Applications page appears.
Select the Application you want to edit, then click Edit.
The RBAR > Configuration > Applications [Edit] page appears.
From the Application ID drop down list, select the Application ID in the Diameter message.
Note that the Routing Mode field is disabled.
Perform one of the following actions:
- Click OK to save the Application and return to the RBAR > Configuration > Applications page.
- Click Apply to save the Application and stay on this page.
- Click Cancel to return to the RBAR > Configuration > Applications page without saving the changes.
If OK or Apply is clicked and any of the following conditions exist, an error message appears:
- The Application Name is not unique; it already exists in the system
- The entry in the Application Name field is not valid (wrong data type or out of the valid range)