Reconnect the following cables that had been disconnected from the Pilot.
Ethernet cables connected to the network ports
Rollover cable connected to the serial port
Note: If the cable management arm (CMA) is in the way, extend the Pilot approximately 13 cm (5 inches) out of the front of the rack. Once the cables are connected to the ports, the Pilot can be pushed back into the rack position.
Reconnect the power cords to the power supplies and secure them with the velcro straps.
If necessary, reinstall the cables into the cable management arm (CMA) and secure them with cable straps.
Reconnect
the CMA to the Pilot chassis by reattaching
the release tabs on both sides of the CMA.