Slide Pilot to Service Position

Slide the Pilot chassis fully forward until the slide rails lock into position.
Figure 1 Pilot position during component replacement

Legend

1 Rack

2 Pilot chassis

3 Pilot rails
When Guided Maintenance prompts you to remove the component, pull the flip handles at front of the Pilot and start sliding the Pilot out of the rack.
Caution
Deploy any rack anti-tilt mechanism before releasing the release buttons and extending the Pilot.

Figure 2 Pilot slide lockout release tabs

Legend

1 Slide rail lock

2 Slide lockout release tab

Note: The slide-rail locks are located behind the flip-down handles on the front of the Pilot chassis. The slide-rail locks are released when the flip-down handles are pulled down. The slide lockout release tab must be released to push the Pilot chassis back into the rack.