Configure ILOM Network

Configure the Integrated Lights Out Manager (ILOM) for the Oracle MaxRep Replication Engine to send hardware fault notices to the Call‑Home server.

Prerequisites

  • Default ILOM password is reset.

    See the Oracle MaxRep for SAN Hardware Guide.

  • IP address to the Oracle FS System Pilot management interface.
    Note: Use the Pilot that is registered to the Replication Engine so that Call‑Home notifications and replication logs originate from the same Replication Engine.

Oracle Customer Support receives critical Oracle MaxRep Replication Engine activity notices by way of the Call‑Home feature of the Oracle FS System. When you configure the Replication Engine network with the ILOM system, you are establishing the connection to the Call‑Home server.

  1. Log in to the Support User Interface page on the control service Replication Engine.
    Result:
    The Dashboard page displays.
  2. Select Management Tasks > ILOM Configuration.
  3. From the Host list, select the Replication Engine that is running the Oracle MaxRep replication services.
  4. Enter the ILOM network information.
    • ILOM IP Address

    • ILOM Subnet Mask

    • ILOM Default Gateway

  5. Enter the Trap Receiver Details.
    Note: Use the IP address to the Oracle FS System Pilot management interface.

When you save your changes, the system displays the Task Status page. You can monitor the task progress and, in some cases, cancel the change from this page.