Replication Engine Installation Checklist

Installation of an Oracle MaxRep Replication Engine is performed by Oracle Customer Support. Certain verifications and actions will be required for each Replication Engine during installation.

Note: Print this installation checklist and check off each task after you complete it.

Table 1 Installation checklist
Installation tasks
Unpack the shipment and inspect all components.
Unpack the Replication Engine outside the data center to ensure that no contamination or dust is released.
Verify that all packing material has been removed and nothing is blocking the fans and air vents.
Gather all the excess spare parts like cables and documentation together.
Always load equipment into a rack from the bottom upwards so that it will not become top-heavy and tip over. Deploy the rack's anti-tilt bar to prevent the rack from tipping during equipment installation.
Install the rack rails and the Replication Engine in the rack.
Launch a remote session to the Integrated Lights Out Manager (ILOM) port. Configure the Integrated Lights Out Manager (ILOM) port password using a laptop prior to connecting the Replication Engine to the customer network using the steps outlined in the ILOM Security Guide..
Label all the cables clearly and use cable binders.
Connect all Fibre Channel (FC) and Ethernet cables as described in this guide.
Configure the operating system on the Oracle MaxRep Replication Engine.

It is important that the Replication Engine has the correct IP addresses upon installation.

Install the correct software version and apply all the required patches and or hotfixes for Oracle MaxRep for SAN.

Verify browser access to the Oracle MaxRep for SAN graphical user interface (GUI) and the command line interface (CLI) for the Replication Engine.