- Lower the riser
onto the Replication Engine motherboard
and press the riser edge connector securely into the socket. Important! Ensure that any HBAs that must be removed from the failed riser and placed onto the replacement rise are inserted into the same slots on the replacement riser.
Figure 1: Insert riser
- Legend
1 Riser 2 Replication Engine motherboard
- After the riser
is seated properly inside the Replication Engine, tighten
the two captive Phillips screws on both sides of the riser to secure
the riser on the Replication Engine motherboard.
Figure 2: Captive screws to secure risers to the motherboard
- Legend
1 Riser 3 with latch 3 Riser 1 2 Riser 2 4 Captive screws
To install riser 3, lock the latch to secure the riser to the Replication Engine motherboard.Figure 3: Riser 3 latch locked
- Legend
1 Riser 3 latch 3 HBA 2 Riser 3
- Reconnect any previously removed internal or external cables to any HBAs installed in the riser.
- Repeat the above steps for any additional risers that you are installing.