- Disconnect any cables that are connected to the HBAs inside the riser.If you have not done so already, note the ports from which the cables are disconnected in the HBA, so that the cables can be reconnected to their original ports when the HBA is replaced.
- Swing the riser retainer latch (for riser 3) to its fully open (180 degrees) position.
Figure 1: Unlock riser retainer latch to release HBA
- Legend
1 Riser retainer latch 2 HBA 3 Riser
- Lift the HBA off of the alignment pin of the riser slot.
Figure 2: Remove HBA from riser slots
- Legend
1 Riser 2 Riser slots 3 HBA