The following procedure is optional.
- From the front of the Replication Engine, press on the slide-rail release tabs on both sides at the front of the Replication Engine, and pull the Replication Engine out of the rack until is free of the rack rails.
Important! Oracle recommends not removing the Replication Engine from the rails for servicing the components. All components are designed for replacement and servicing while the Replication Engine chassis is on the rails. However, if you must remove the Replication Engine from the rack, disconnect the rear panel Replication Engine cables from the front with the Replication Engine in service position.
Note: A slide-rail release tab is located on each slide-rail of the Replication Engine.
- With the help of a partner or a mechanical lift, place the Replication Engine on an antistatic surface on a workbench.