This chapter contains the topic:
When you are ready to burst a report, ensure that it is in the output queue, EBBSTART. If the spool files are in an output queue other than EBBSTART, you must change the output queue to EBBSTART.
To move spool files to EBBSTART
From Electronic Burst and Bind (G98E), choose Maintain EBB Versions
On Maintain EBB Versions, enter 5 in the Option field next to the version to which you want to move the spool files.
On Spool File Selection, enter the output queue in which your spool files reside in the OUTQ field.
Enter 2 in the Option field for the first file.
The file no longer displays on the screen because it is now in the EBBSTART output queue.
Repeat the previous step for each spool file. After you move all files in the output queue to the EBBSTART output queue, the following message displays:
Version (Version ID) report was not found in this OUTQ
Enter EBBSTART in the OUTQ field and press Enter.
The spool files display.