E Quick Instructions to Set up Extensibility

This appendix contains these topic:

• Section E.1, "Quick Instructions to Set up Extensibility,"

E.1 Quick Instructions to Set up Extensibility

To set up Extensibility

1. Run a full Cross Reference, or for a single program. (6/G9642).

2. Verify the Event Master record exists. (2/G98X).

3. Verify an SVR record exists for the calling and called programs. (6/G98X).

4. Verify the Program Exports are defined. (5/G98X).

5. Verify the copy modules D98XBASE and C98XBASE are inserted into the source code of the calling program.

6. Verify the Event Copy modules are inserted into the source code of the calling program.

7. Verify the program compiles successfully after the Program Exports have been defined and anytime the Program Exports are changed.

8. Generate the F98016 record using P98016B (10/G98X). The PLIST (*ENTRY) parameters must be defined in the F98016 file. (11/G98X).

9. Verify the Mapping Parameter Values are defined. (12/G98X).

10. Verify the Extension Master record is defined. (14/G98X).

11. If the extension requires a Named Condition, complete the set up before proceeding. (23/G98X).

12. Verify the Program Event Extension is defined. All previous steps, except step 11, must be completed before creating the Program Event Extension. (15/G98X).

13. Enable the Event Extension through the Extensibility Workbench (22/G98X).