Create Oracle Engineered Systems (Oracle SuperCluster) Report

Procedure to create Oracle Engineered (Oracle SuperCluster) Systems report in Oracle Enterprise Manager Ops Center.

Reports provide information about assets, such as job history, firmware, operating system updates, and incidents. Reports are created in Interactive, PDF, and CSV formats. You can generate and view the report for multiple Oracle Engineered Systems.

Perform the following steps to create a report for Oracle Engineered System in Oracle Enterprise Manager Ops Center.

1. In the Navigation pane, click Reports.

   Figure 3-5 Create Reports

   
   Description of "Figure 3-5 Create Reports"
2. Click Oracle Engineered System Reports.
3. In the Actions pane, click Create Oracle Engineered System Report.
4. In the Define Report Parameters wizard, enter a name and description for the report. The Schedule and Output Format are checked by default.

   Figure 3-6 Define Report Parameters

   
   Description of "Figure 3-6 Define Report Parameters"

   • Select Create Schedule to run the report later or on a recurring schedule.

   • Select the output formats of the result that will be generated for the report.

5. In the Targets section, select the asset for which you want to run the report and click Add to Target List.
6. Click Next. The Schedule wizard is displayed.
7. Select a schedule for the report. You can schedule the report to run on the following instances:

   • Now: Runs the report immediately.

   • At a later date/time: Select a date and time to generate the report.

   • On a Recurring Schedule: Select the month and day when you want to generate the report. Select the Start Time, End Time, and Number of Hours between runs. This is to set the number of times the report is generated between the specified start and end time. For example, if you set the start time at 6.00 a.m, end time at 12.00 a.m, and the number of hours between runs as 2, then the report is run at 6.00 a.m, 8.00 a.m, 10.00 a.m, and 12.00 a.m.

8. Click Next. The Summary wizard is displayed.
9. Verify the report parameters and click one of the options as required:

   • Save Template and Close: Saves the report as a template and closes the wizard. You can use the report template to generate the report later.

   • Run and Close: Runs the report and closes the wizard window.

   Figure 3-7 Report Created

   
   Description of "Figure 3-7 Report Created"

Viewing Engineered Systems Reports

Using reports, you can view the rack setup for each of the rack within the system, including the asset details related to the rack.

To view an Engineered System Report, perform the following steps.

1. In the Navigation pane, under Reports, select Oracle Engineered System Reports.
2. Select a report and click the format in which you want to view the report.

   Figure 3-8 View Report

   
   Description of "Figure 3-8 View Report"

   The report is displayed in the selected format.

Baseline Check

Baseline Check is a feature in Oracle Enterprise Manager Ops Center Engineered Systems where the factory default configuration of eighth, quarter, half, and full rack configurations are considered as a normal or baseline setup.

When the assets are discovered and associated with the rack, this setup is compared with the default factory configuration. If any discrepancy is found, the baseline check displays a question mark on the slot in the rack where the local configuration differs from the factory default configuration.

Hover the cursor over the question mark to view details of the warning, for example, missing asset, asset mismatch, or unknown asset. Based on the warning, you can decide to adjust and move the assets in the rack.