Remove a Riser

Press on the retention clip that secures faceplate of the riser and release the riser from the Pilot motherboard.
Note: There are three riser board assemblies inside the Pilot chassis. The SAS HBA is located on the third riser and the other risers are empty.

Caution
Do not disconnect the SAS cable from the internal SAS HBA until after you have removed the riser from the Pilot.
Carefully pull up the PCIe riser lever on the riser to release the riser and HBA card (if any).
Figure 1: Remove the riser

Legend

1 Retention clip

2 PCIe riser lever

3 Slide card retainer

4 Riser and HBA assembly

5 Riser faceplate
Unlock the slide card retainer to release the riser from the Pilot.
Tip: You might need to remove fan module (FM–0), which is the left most fan when viewing the Pilot from the front.
Using the PCIe riser lever, pull the riser straight up.