Configuring the Transaction Services Workstation Client

You can configure Transaction Services to run on the same hardware device as a Simphony client. Kiosks are usually configured as Transaction Services clients. Obtain the following information before you begin the configuration:
  • Transaction Services workstation name

  • Number of revenue centers using Transaction Services

  1. In the EMC, select the property, click Setup and Workstations.
  2. Insert a record and enter the workstation name.
  3. Double-click the workstation record.
  4. In the Type field, select 3 - POSAPI Client.
  5. Select the Service Host ID where the workstation will run.
  6. In theAddress / Host Name field, enter the machine where Transaction Services is installed.
  7. Click the Transactions tab.
  8. Enter the Minimum and Maximum Check Numbers to use.
  9. In the Default Order Type field, select the order type that the Transaction Services workstation client uses.
  10. Ensure that the Cash Drawer Settings show 0 (zero).
  11. Click the Order Devices tab.
  12. Select all order devices that use the Transaction Services client for the revenue center shown in the list. If multiple revenue centers use Transaction Services, select the appropriate order devices for each revenue center.
  13. Click the Printers tab.
  14. Select the printer to use for each print job.
  15. Click the Revenue Centers tab.
  16. Select the revenue centers in which this instance of Transaction Services operates.
  17. Ensure that no peripheral devices appear on the Devices tab.
  18. Click Save.
  19. Repeat Steps 1 through 18 for each Transaction Services workstation client.