Message to Terminal

After clicking on button Message to terminal in window Terminals the following window is opened:

Field Text is empty when it is first called up after a system start (or if no text has been programmed). In all other cases the last text called up will be displayed.

It is also possible to either send an existing text or to program it and then to send it.

A. An existing text is to be sent

  1. Retrieve the text to be sent by entering the no. in "Texts" or selecting it via the Search function.
  2. As soon as the text appears, click on button Send message.
  3. The window which then opens asks Are you sure? Click on ok to send the message. (Abort leads to end of function).
    The message is sent and shown in the display or on the operator’s screen. The message is accompanied by an acoustic signal. (The operator must acknowledge the incoming message with key C).
  4. Message OK appears on the screen. This message is finalised after confirmation with OK.
    Note:
    If the system discovers that the message has not been received it signals "No port free".
  5. Other messages can be sent or the function can be completed with a click on Close.

B. A non-existent text is to be sent

  1. Click on the button next to the arrow to change to the appropriate update program. You are now in window Text or Text groups. A 20-pos. text can be entered. As only texts of text group 100 can be updated only this text group will appear. A change of text group is not possible. Please read the information under Text or Text groups.
  2. After programming the new text, storing it and closing the window, the system returns to the first window.
    The steps described under 2. - 5. above should then be carried out.

Note:


MICROS Retail Deutschland GmbH
Salzufer 8
D-10587 Berlin