Use the oakcli add disk -local
command to add a local disk to the system after physically replacing a failed disk.
Note:
This command is available only for Oracle Database Appliance X4-2, X3-2, and V1.
Syntax
oakcli add disk -local
Usage Notes
You cannot add more than two disks per node.
You must remove the failed drive and replace it with a new drive before running the oakcli add disk -local
command.
The new disk must be inserted into the slot before you run this command.
The oakcli add disk -local
command is supported only on bare metal deployments. It is not supported on virtualized configurations.