Perform this procedure to verify that the quorum configuration was completed successfully and that cluster installation mode is disabled.
You do not need to be the root role to run these commands.
phys-schost$ clquorum list
Output lists each quorum device and each node.
phys-schost$ cluster show -t global | grep installmode installmode: disabled
Cluster installation and creation is complete.
Determine from the following list the next task to perform that applies to your cluster configuration. If you need to perform more than one task from this list, go to the first of those tasks in this list.
If you want to change any private hostnames, go to How to Change Private Hostnames.
If you want to install or modify the NTP configuration file, go to Configuring Network Time Protocol (NTP).
If you want to install a volume manager, go to Configuring Solaris Volume Manager Software .
If you want to create cluster file systems, go to How to Create UFS Cluster File Systems.
To find out how to install third-party applications, register resource types, set up resource groups, and configure data services, see the documentation that is supplied with the application software and the Planning and Administering Data Services for Oracle Solaris Cluster 4.4.
When your cluster is fully configured, validate the configuration. Go to How to Validate the Cluster.
Before you put the cluster into production, make a baseline recording of the cluster configuration for future diagnostic purposes. Go to How to Record Diagnostic Data of the Cluster Configuration.
Make a backup of your cluster configuration.
An archived backup of your cluster configuration facilitates easier recovery of the your cluster configuration. For more information, see How to Back Up the Cluster Configuration in Administering an Oracle Solaris Cluster 4.4 Configuration.