Installing the 10-Inch Customer Display with Pole Mount

1. To attach the 10-Inch Customer Display with Pole Mount to a cash drawer or other surface without a cable routing hole:
   1. Tighten the pole base plate captive screws, if required.
   2. Use pliers or similar tool to break off a cable routing tab located along the rear edge of the pole base plate.
   3. Guide the cables through the tab opening in the base plate.
   4. Attach the 10-Inch Customer Display with Pole Mount to the cash drawer or other surface using the four #8-32 base plate screws.
2. To attach the 10-Inch Customer Display with Pole Mount to surfaces with a cable routing hole:
   1. Tighten the pole base plate captive screws, if required.
   2. Guide the cables through cable routing hole.
   3. Attach the 10-Inch Customer Display with Pole Mount to the surface using the four #8-32 base plate screws.
3. Connect the 10-Inch Customer Display with Pole Mount power cord and high definition display cable to the Workstation 6 Series I/O panel.
4. To power on the 10-Inch Customer Display with Pole Mount, press the power button on the rear of the unit.