Signaling test maintenance

The Tekelec HLR Router > Maintenance > Test page allows you to test signaling logic on the specified Message Processor. This allows you to see what would happen if a message was received with arbitrary MTP/SCCP parameter values without actually initiating network traffic. The Message can be routed via SCCP or Map Layer Routing.

To run a test you input an OPC, DPC, CdPA TT, CdPA SSN, CdPA/Map Layer NAI, Map Layer Digit Type, CdPA GTA/Map Layer Digits and then select the MP to run the test on. The test runs the application routing logic on the selected MP. This is not the live routing logic, so no measurements or alarms are triggered, but the test makes the same decisions as the live routing logic based on the configuration of the HLR Router.

After the test is run the following information is displayed on the GUI:

An explanation of its routing decisions including what values it based the decisions on.
The result of all database lookups, including the inputs to the lookup.
The destination to which the output message would have been sent.

This page is only available when logged into an SOAM.