Inserting a service configuration

You can only perform this task when logged into the Active Primary NOAM.

Select Tekelec HLR Router > Configuration > Service Config
The Tekelec HLR Router > Configuration > Service Config page appears.
Click on Insert located below the table.
The Tekelec HLR Router > Configuration > Service Config [Insert] page appears.
Enter the trasnalation type in the TT field.
Enter the subsystem number in the SSN field.
Select the numbering plan from the NP pulldown.
Select the nature of address from the NAI pulldown.
Select the type of service from the Type of Service pulldown.
For HLR, the Type of Service is always HLRR (HLR Routing).
Perform one of the following:
- Click OK to save the signaling service configuration and exit this page.
- Click Apply to save the signaling service configuration and remain on this page.

The service configuration is added and can now be used by the HLR to determine the associated numbering plan and provide proper treatment of a message for the duration of signaling message processing.