Adding a throttling rule

You can only perform this task when logged into the Active Primary NOAM.

Use this procedure to configure a new throttling rule.

Note that the Opcode and MP group selected in a throttling rule must be provisioned prior to configuring this rule. Also, a new rule cannot share its combination of Opcode, Source Address Prefix, and Destination Address Prefix with any existing throttling rule.

Note: A maximum of 1,000 rules can be configured. Once the maximum number has been defined, no additional rules can be added.
  1. Select Tekelec HLR Router > Configuration > Throttling > Rules.

    The Tekelec HLR Router > Configuration > Throttling > Rules page appears.

  2. Click Insert at the bottom of the page.

    The Tekelec HLR Router > Configuration > Throttling > Rules [Insert] page appears.

  3. Enter values into the required fields: Name, Opcode, Destination Address Prefix, Source Address Prefix, and MP Group.
  4. Enter values into the optional fields, as needed.
  5. Perform one of these options:
    • Click OK to save the throttling rule configuration and exit this page.
    • Click Apply to save the throttling rule configuration and remain on this page.
The throttling rule is added to the table, and an Insert success message is displayed.
Parent topic: Throttling rules