22003 - Application ID Mismatch with Peer

Event Type:

DIAM

Description:

While attempting to route a request message to a peer, a peer's transport connection was bypassed because the peer did not support the Application ID for that transport connection.

Severity:

Info

Instance:

<MPName>

HA Score:

Normal

Throttle Seconds:

10

OID:

eagleXgDiameterApplicationIdMismatchWithPeerNotify

Recovery:

1. The system's peer routing table may be using a Route List containing a peer which does not support the Application ID or the list of Application IDs supported by the peer on each connection may not be the same. The list of Application IDs that the peer supports on each connection can be viewed as follows:
   1. Navigate to the GUI page: Diameter > Maintenance > Connections
   2. Locate the relevant Peer Node and check the supported Application IDs.
2. If Application IDs are not the same for each connection (but should be) the Application ID for any connection can be refreshed by:
   1. Navigate to the GUI page: Diameter > Maintenance > Connections
   2. Locate the relevant Connection
   3. Disable the Connection
   4. Enable the Connection
3. The Diameter Node which originated the message (identified by the Origin-Host AVP) could be configured incorrectly and the application is trying to address a node which doesn't support the Application ID. This cannot be fixed using this application.
4. If the problem persists, contact unresolvable-reference.htm#GUID-DD0927BD-FD0B-4CEB-86E9-98A33C12D4E0.