22205 - Answer Message Queue Utilization
- Alarm Group:
- DIAM
- Description:
- The MP's Answer Message Queue Utilization is approaching its maximum capacity. If this problem persists and the queue reaches 100% utilization all new ingress Answer messages will be discarded. This alarm should not normally occur when no other congestion alarms are asserted.
- Severity:
- Minor, Major, Critical
- Instance:
- N/A
- HA Score:
- Normal
- Auto Clear Seconds:
- 0 (zero)
- OID:
- eagleXgDiameterAnswerMessageQueueUtilNotify
Recovery:
- If one or more MPs in a server site have failed, the traffic will be distributed between the remaining MPs in the server site. MP server status can be monitored from the page.
- The mis-configuration of Diameter peers may result in too much traffic being distributed to the MP. The ingress traffic rate of each MP can be monitored from the page. Each MP in the server site should be receiving approximately the same ingress transaction per second.
- There may be an insufficient number of MPs configured to handle the network traffic load. The ingress traffic rate of each MP can be monitored from the page. If all MPs are in a congestion state then the offered load to the server site is exceeding its capacity.
- If no additional congestion alarms are asserted, the Answer Task may be experiencing a problem preventing it from processing messages from its Answer Message Queue. The alarm log should be examined from the Alarms & Events page.
- If the problem persists, it is recommended to contact My Oracle Support.
