Go to primary content
User Data Repository Diameter User's Guide
Release 12.4
E92984-01
Contents
Previous
Next
Adding a Peer Routing Rule
Use this task to create a new Peer Routing Rule in a Peer Route Table.
Click
Diameter
>
Configuration
>
Peer Route Tables
.
Select the Peer Route Table to which you want to add a Peer Routing Rule and click
View/Insert Rules
.
Click
Insert
.
Enter a unique name for the Rule in the
Name
field.
Set a Priority for this Rule in relation to other Rules by entering a number between 1 and 99 in the
Priority
field.
Set the Peer Routing Rule
Conditions
:
Locate the
Parameter
you want to set.
Select the relevant operator from the
Operator
list. See
Peer Routing Rule operators
for a description of operators available for each parameter.
Enter the appropriate value for the parameter in the corresponding
Value
field.
Repeat this step for each parameter. For any parameter that does not need to be evaluated, set the
Operator
to
Always True
.
Select the
Action
you want to occur when a Diameter message matches the parameter conditions.
Route to Peer
: route the message to a Peer Node using the Route List associated with this Rule.
Send Answer
: abandon message routing and send an Answer response containing the
Answer Result-Code Value
associated with this Rule.
If you selected
Route to Peer
as the Action, select the
Route List
to associate with this Rule from the list.
If you selected
Route to Peer
as the Action, select the
Message Priority
to assign to the message.
If Diameter Message Copy is used, select the
Message Copy Configuration Set
to use when this Rule is selected for PRT-triggered Message Copy.
If you selected
Send Answer
as the Action, select the desired
Answer Result-Code Value
selection box:
Select the option to use an existing Answer Result-Code, then select an Answer Result-Code in the list.
Select the option and enter your own Answer Result-Code value.
If you selected
Send Answer
as the Action, enter the desired Vendor ID AVP in the
Vendor ID
field.
If you selected
Send Answer
as the Action, enter the desired Error-Message AVP in the
Answer Error Message
field.
Click
OK
,
Apply
, or
Cancel