Adding Traffic Throttle Groups

Use this task to create a new Traffic Throttle Group.

The fields are described in Diameter Traffic Throttle Groups elements.

Note:

When you select an Application Id to the Traffic Throttle Group, you are only allowed to select the TTP whose application ID matches the application ID that of Traffic Throttle Group.

1. Click Diameter > Configuration > Traffic Throttle Groups.
2. Click Insert.
3. Enter a unique name in the Name field.
4. Select or enter the element values.
5. Click OK, Apply, or Cancel.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • Any required field is empty (no value was entered).
   • The value in any field is not valid or is out of range.
   • The Name is not unique; it already exists in the system.
   • The maximum number of TTGs has already been configured.