You can perform these tasks on an Active System OAM (SOAM).
IPFE Connections
Note:
Only IPFE Diameter connections are supported at this time.Fixed connections are configured with a static DA-MP IP address, where the connections are established on a specific DA-MP.
IPFE Initiator connections, the target set address, is the source address. It provides additional flexibility in assigning and using IP address efficiently in your configuration.
The default is Initiator & Responder provides additional flexibility and allows you to use any port within a configurable range on any DA-MP within a TSA to initiate connections.
IPFE connections are configured with a public TSA IP address and a static listening port, and IPFE Initiator connections are configured with a static initiator DA-MP and a public TSA IP address and a user-selected or automatically selected static initiator port.
The IPFE Initiator port range division depends on the connection type (fixed or floating IPFE) and the selection method (user-configured or system-selected).
Note:
When overall connection counts are calculated, RADIUS connections are treated like fixed connections.Port ranges for IPFE initiator connections are 1024-49151. You cannot configure a port range outside of this range; the GUI generates a message and corresponding explanation.
Note:
You cannot select a port value for IPFE responder, as diameter does not initiate these types of connections.Note:
Port Number flexibility combines the Responder and Initiator Port Ranges into one large port range. It also eliminates per DA-MP port ranges and port ranges set aside for user input or DCL.Connection Capacity Validation
The Connection Capacity Validation function validates and limits the configuration of Diameter Connections to better ensure that the configuration does not violate the Connection Count or Reserved Ingress MPS capacity limitations of the DA-MP servers that handle Connections in real time.
Note:
All message types contribute to the ingress MPS rate of the connection; however, only routable request messages are subject to discard or reject actions.An error displays, stating the reason, when the validation determines that performing the configuration action would cause over-configuration of Connections or Reserved Ingress MPS in a DA-MP or Target Set, or that a configuration action cannot be performed for another reason such as no MP Profile assigned to the subject DA-MP.
A warning displays when the validation cannot determine whether the configuration action would cause over-configuration of Connections or Reserved Ingress MPS in a DA-MP or Target Set.
If an error and a warning could apply, the error displays.
If a Responder Only connection is created without a Peer Node IP Address and Transport FQDN is selected, Transport FQDN is required even though it is not applicable.
page displays the current Connection Count and Reserved Ingress MPS data per DA-MP. The page functions and contents are described in