Adding a Peer Route Table

Use this task to create a new Peer Route Table. The fields are described in Diameter Peer Route Tables elements.

1. Click Diameter > Configuration > Peer Route Tables.
2. Click Insert.
3. Enter a unique name for the Peer Route Table in the Peer Route Table Name field.
4. Click OK, Apply, or Cancel.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • Any required field is empty; no value was entered or selected
   • The entry in any field in not valid (wrong data type or out of the valid range)
   • The Peer Route Table Name is not unique; it already exists in the system
   • The maximum number of Peer Route Tables (500) already exists in the system

After a Peer Route Table is added, Peer Routing Rules can be defined for it. See Peer Routing Rules configuration. For information about required component configuration order, see Understanding the Diameter Configuration Sequence.