Disabling All Connections

Use the following steps to disable all connections that are displayed as result of the application of a filter. If a filter is applied, then all connections that meet the filter requirements and that are currently enabled are disabled. If no filter is applied, then all currently enabled connections are disabled.

1. Click Diameter > Maintenance > Connections.
2. Optionally, click Filter and add up to four filters to limit the number of connections displayed. Click Go to apply the filter.
3. Click Disable All.
4. Click OK on the confirmation screen to disable the connections.
   If any of the selected connections no longer exist (they have been deleted by another user), an error message is displayed, but any selected connections that do exist are disabled.