This section explains the procedure to configure
Pool Spanning feature.
To
configure Pool Spanning functionality:
-
Install and
configure User Data Repository product on multiple machines. For example, UDR1
and UDR2.
-
Configure ComAgent
on OCUDR1 and OCUDR2 as described in the Configuring ComAgent for UDR Machines.
-
Configure Pool Network Table on UDR1 and UDR2. See, Configuring
Pool Network.
-
Add entries in the UDR Key Range table on UDR1 and UDR2 for the
pool id ranges. See, Inserting UDR Key Range.
-
Optional) Execute the following command on Active NO as a root
user only for systems upgraded from User Data Repository product release 12.1
to User Data Repository product release 12.2.
This step is not required for a system upgraded from User Data
Repository product release10.2 or a new installation of User Data Repository
product release 12.2.
iset -fflags=0 Subscription where
"flags!=0"
The command may take up to three hours to complete for a 30M
Database. Proceed to step 6 only after completion of Step 5.
-
Run the following command to activate Pool Spanning on Active NO
as a root user on User Data Repository system product.
iset -fvalue=TRUE CommonOptions where
"var='PSO_Enabled'"
iset -fvalue=TRUE CommonOptions where
"var='PoolProfileMergeEnabled'"
You
have successfully configured the Pool Spanning Feature.